第一天
Workshop 1 : Basic Input and Output
Workshop 2 : Linear Static Analysis of a Cantilever Beam : Multiple Load Cases
Workshop 3 : Nonlinear Statics
Workshop 4 : Unloading Analysis of a Skew Plate
Workshop 5 : CLD Analysis of a Seal using Abaqus/Standard
Workshop 6 : Dynamics
Workshop 7 : Contact with Abaqus/Explicit
Workshop 8 : Quasi-Static Analysis
Workshop 9 : Import Analysis

第二天
Lesson 05 : Assemblies in Abaqus(Abaqus 中的裝配)
Lesson 06 : Steps, Output, Loads, and Boundary Conditions（時間步長、輸出、負載和邊界條件）
Lesson 07 : Meshing Imported and Native Geometry（導入網格與原生幾何）
Lesson 08 : Job Management and Results Visualization（工作管理器及結果後處理）

Workshop 5a : Defining Steps, Interactions, Boundary Conditions, and Loads - Hinge Model
Workshop 5b : Defining Steps, Interactions and Boundary Conditions - Clip and Plate Model
Workshop 6a : Three-Dimensional Meshing - Hinge Model
Workshop 6b : Two-Dimensional Meshing - Fuse Model
Workshop 7a : Job Management and Visualization—Hinge Model
Workshop 7b : Visualizing Results and Modifying the Model Definition—Clip and Plate Model

第三天
Lesson 09 : Linear and Nonlinear Problems(線性及非線性問題)
Lesson 10 : Analysis Procedures (Part 1)（分析步驟 : Part 1 ）
Lesson 11 : Analysis Procedures (Part 2)（分析步驟 : Part 2 ）
Lesson 12 : Analysis Procedures (Part 3)（分析步驟 : Part 3 ）
Lesson 13 : Analysis Continuation Techniques(分析連續技術)
Lesson 14 : Constraints and Connections（拘束及連接）
Lesson 15 : Contact（接觸）
Appendices（附錄）
Workshop 1 : Basic Input and Output
Workshop 2 : Linear Static Analysis of a Cantilever Beam : Multiple Load Cases
Workshop 3 : Nonlinear Statics
Workshop 4 : Unloading Analysis of a Skew Plate
Workshop 5 : CLD Analysis of a Seal using Abaqus/Standard
Workshop 6 : Dynamics
Workshop 7 : Contact with Abaqus/Explicit
Workshop 8 : Quasi-Static Analysis
Workshop 9 : Import Analysis